新德里工业用水工业废水聚合

水处理絮凝剂和其他絮凝剂使用顺序添加方法混合：
　　使用复合絮凝剂时，必须注意添加顺序和添加之间的时间间隔！ PAC和PAM的组合是让PAC完成中和电荷/胶体去稳定化以形成精细絮凝物，并进一步增加絮凝物体积以促进充分沉淀。由于水处理絮凝剂PAC反应时间很短，加入后需要强力搅拌，PAM作用时间长，先混合注意力强，然后弱强度——首先要强力均匀混合，以免破坏絮状物！
　　水处理絮凝剂属于絮凝剂，聚合是凝结剂。通常，凝结剂中加入聚合铝和聚酰胺絮凝，但为了安全起见，建议用实验效果确定添加顺序！剂量点，给药量，给药时间和混合强度需要通过实验确定。切记永远不要一起使用它们，否则会影响效果并增加使用成本。



Water treatment flocculant and other flocculants are mixed by sequential addition method:

When using composite flocculant, attention must be paid to the addition sequence and the time interval between additions! The combination of PAC and PAM is to allow PAC to complete neutralization charge / colloid destabilization to form fine flocs, and further increase the floc volume to promote full precipitation. Because the reaction time of water treatment flocculant PAC is very short, it needs strong stirring after adding. PAM has a long action time. First, the mixing attention is strong, and then the strength is weak - first, it needs strong and uniform mixing to avoid damaging the flocs!

Water treatment flocculant belongs to flocculant, and polyaluminium chloride is coagulant. Generally, polyaluminum and polyacrylamide are added to the coagulant for flocculation, but for the sake of safety, it is recommended to determine the addition order with the experimental effect! The dose point, dosage, administration time and mixing intensity need to be determined through experiments. Remember never to use them together, otherwise it will affect the effect and increase the use cost.